120cm Flexible Waterproof Blue LED Light Ribbon (DC 12V)

Specifications:

• Low voltage
• This 120cm LED Light Ribbon is suitable for DC 12V power supply
• This Waterproof LED Light is energy saving and environment protection
• Waterproof for both exterior and interior use
• This LED Light Ribbon can be installed in concave-convex surface
• This LED Light Ribbon can be used night light, a garden decoration, a party decoration, a holiday decoration, ceiling, car, furniture, building or other place
• This LED flexible ribbon can be cutted at the cutting can be connected up to 5m freely
• Color of Light: Blue
• Number of LED: 120
• Length: 120cm / 47.2in

Details:

• Save energy while you light up the night with this Waterproof LED Light. The clip allows you to decorate almost anything

• You no longer need to worry about tripping over extension cords or staying close to a power outlet. Now you can decorate in even the most remote locations

• 47.2in 12V LED Flexible Light Strip is very soft, super bright, light, colorful. This LED Light Ribbon can play a great role to help you, and can be connected freely

• A festive addition to the party, backyard or campsite, This LED Light Ribbon features ten miniatures of the classic, instantly-recognizable shape of Coleman lanterns

It can be used car:

It can be used indoor:





It can be used outdoor:

How to Connect Motorcycle LED Lights:

• Locate areas under the motorcycle body or fairing where you would like to install the LED lights. Ensure that there are no hot motorcycle parts close to the locations you pick
• Clean the areas where you will be installing the lights with alcohol prep pads. This removes the dirt and grime. Allow the alcohol to dry thoroughly so the LEDs will have a clean, dry surface to attach to
• Remove the adhesive backings on the LEDs and install them by pressing them firmly against the motorcycle surface. Most LED light strips are flexible and can be curved around the fairing for better illumination
• Remove the seat and run the wires through the frame of the body to underneath the seat where the battery is located. The wires should not be visible on the outside of the bike
• Collect all the wires and tighten them together with a wire tie. This keeps the wires organized
• Loosen the terminal bolts on the motorcycle battery by using your screwdriver. Tighten the terminal bolts back into place so they firmly hold the wires down
• Start your motorcycle and watch your LEDs light up. If all or some of the LEDs are not operating properly, check the battery terminal connections first to ensure that they are tight. If the problem is not resolved, check the clamp connector wiring to ensure that all the wires are stripped properly and in full contact with the inside of the connector

Package Included:

• 1 x 120cm Flexible Waterproof LED Light Ribbon