Specifications:

• Brand new 12V flexible waterproof led strip light
• Used in your car, motorcycle, boat, pc, rv, bike, garden for decoration
• Flexible strip can be bent into desired shapes
• LED flexible ribbon can be cutted at the cutting can be connected up to 5m freely
• Color of Light: White
• Number of LED: 120
• Length: 120cm / 47.2in

Details:

• Brand new 12V flexible waterproof led strip light

• Flexible strip can be bent into desired shapes

It can be used car:

It can be used indoor:





It can be used outdoor:

How to Connect Motorcycle LED Lights:

• Locate areas under the motorcycle body or fairing where you would like to install the LED lights. Ensure that there are no hot motorcycle parts close to the locations you pick
• Clean the areas where you will be installing the lights with alcohol prep pads. This removes the dirt and grime. Allow the alcohol to dry thoroughly so the LEDs will have a clean, dry surface to attach to
• Remove the adhesive backings on the LEDs and install them by pressing them firmly against the motorcycle surface. Most LED light strips are flexible and can be curved around the fairing for better illumination
• Remove the seat and run the wires through the frame of the body to underneath the seat where the battery is located. The wires should not be visible on the outside of the bike
• Collect all the wires and tighten them together with a wire tie. This keeps the wires organized
• Loosen the terminal bolts on the motorcycle battery by using your screwdriver. Tighten the terminal bolts back into place so they firmly hold the wires down
• Start your motorcycle and watch your LEDs light up. If all or some of the LEDs are not operating properly, check the battery terminal connections first to ensure that they are tight. If the problem is not resolved, check the clamp connector wiring to ensure that all the wires are stripped properly and in full contact with the inside of the connector

Package Included:

• 1 x 120cm Flexible Waterproof LED Light Ribbon