-
-
Specifications:
- Operating Voltage: 5.0VDC ±0.5V
- Operating Current: ≤3mA(5.0VDC)
- Modulation: ASK / OOK
- Operating Frequency: 250MHz-450MHz
- Bandwidth: 2MHz (315MHz, sensitivity decreases when 3dBm test)
- Sensitivity: Better than-105dBm (50Ω)
- Rate: <5Kbps (315MHz,-95dBm)
- Antenna Length: 24cm(315MHz), 18cm(433.92MHz)
- Can be used in a variety of low-rate digital signal reception
- Can be used in industrial remote control, telemetry, remote sensing
- Can be used in anti-theft alarm signal reception, all kinds of household electrical appliances such as remote control
Details:

- Can be used in anti-theft alarm signal reception, all kinds of household electrical appliances such as remote control
How to Build a Wireless Remote Control:
- Open the remote control housing and place a push button switch on the side. In the upper right corner of the housing, fasten a 3-volt battery holder. Be sure enough room is available to install and remove the battery.
- Run a wire from the push button switch and link to the 3-volt battery holder at the negative connection. Attach another wire to the push button switch and lead it to the Meg 1/4W resistor and the NPN silicon transistor. Run a third wire from the Meg 1/4W resistor and attach it to the 22K 1/4W resistor and and the PNP silicon transistor.
- Position the infra-red LED on the front of the housing. Attach the LED and run wires to both transistors. From the 22K 1/4W resistor, run a wire to the C220.01uF 16v ceramic disk capacitor. Run another wire between the NPN silicon transistor and the ceramic disk capacitor.
- From the positive connector on the 3-volt battery holder, connect a wire to the PNP silicon transistor. This will allow for proper current flow in a closed circuit. Ensure the push button switch is positioned to "off" and place a 3-volt battery into the holder. Close the remote control housing.
- Point the remote control at a receiver, making sure the LED on the control is aimed at the LED of the receiver. Push the button and the receiver should power on and off. To adjust the receiver to be programmed, point the remote control and hold down the push button switch. Adjust the pot or taper on the receiver until you hear a click. This links the remote control and the receiver.
Package Included:
- 1 x Wireless Receiving Module
Get DinoPoint™ by Writing reviews, Post Images, or Post Videos. The first five customers can get double points!
Maybe you are interested in:






















































