Infrared 48 LED Illuminator Board Plate for CCTV Security Camera FY-16048 GA

Specifications:

• Replace a CCD camera LED board for your broken or worn out IR LED board
• Here is a IR LED board for CCTV security cameras
• Great performance without much energy consume
• This is a IR LED board for CCTV security cameras
• Replace a LED Board for your broken or worn out IR LED board
• Great performance without much energy consume
• The CCTV camera IR infrared illuminator board plate contains 48 IR LED which can illuminate up to 15 / 30 / 45 / 60 / 80 degree spread angle
• Very bright Infrared LED board
• Angle: 15 / 30 / 45 / 60 / 80
• Number of IR Lamp: 48 LED Φ5
• Diameter: 60mm / 2.36 in

Details:

• Very bright infrared LED illuminator board plate with 48 lights.This Camera Illuminator Board Plate is easy to clean and do not rust. A great replaceable LED board for your broken or worn out IR LED board

• Built-in auto protection circuit against damaging the illuminator board plate by high voltage.Great performance with low level energy consumption. Add a distinctive flair to your CCTV video camera with this fantastic illuminator board plate

• The actual size of the illuminator board plate.This is a Infrared 48 LED Illuminator Board Plate for CCTV Security Camera .Replace such Camera Illuminator Board for your CCTV security camera. LED Illuminator Board Plate for the CCTV security cameras

Illuminator Board Plate



Operating Instructions for IR Illuminators:

• Turn off your security camera system so there is no live current flowing through the system. Place a ladder against the wall securely so that you can reach the security camera you want attach the IR illuminator to. Screw the attachment plate that came with the IR illuminator to the side of the IR camera. There are two screw holes on the side of the camera for the attachment plate and the screws came with the IR kit. Then screw the IR illuminator to the attachment plate with the other two screws included in the kit
• Loosen the screws that secure the IR camera to the camera mount and flip the camera to the side to expose the underside of the IR camera. Rotate the back end of the IR camera off to expose the inside of the IR camera. Thread both wires through their waterproof seals. Thread the control wire and the power cord through the hole on the bottom and pull those wires towards the rear of the inside of the camera. Locate the control cable port, it will look like the underside of a lego piece, press the camera control plug into the port. Then locate the power port and plug the power cord into the port
• Rotate the back of the IR camera back onto the end of the camera. Screw down all four of the waterproof seals, one for each wire end. The seals should be flush with the side of the ports. Flip the IR camera back onto the mount and rescrew it down. Turn your security camera system back on and turn the IR camera on. The IR illuminator will automatically come on. Compare the image with the area that you want to monitor, go back and adjust the IR camera on it's mount to give a better image if it is a fixed camera. If the camera can rotate under it's own power then move the camera via the joystick on the camera control board

Package included:

• 1 x CCTV Camera Illuminator Board Plate