67mm Three Way Soft Rubber Lens Hood for Digital & Film Camera

Specifications:

• The hood is for use with any type of lens and fits a standard 67mm thread
• Provides protection from unwanted light flares and from accidental physical damage
• Provides the solution to the problems caused by sun glare, rain and wind-blown debris
• This triple-position rubber lens hood covers different focal lengths
• The rubber material is acid proof and temperature insensitive
• This is an original product
• Material: Matt black rubber hood and metal thread
• Thread Diameter: 67mm / 2.64in
• Size: 28 x 67mm / 1.1 x 2.6in(H x Dia.)

Details:

• One of the most important accessories for each lens you own

• Designed to match the specific focal length of the lens

• Allowing handheld photography even in low-light situation

How to Use Lens Hood in Studio:

• Remove the lens cap from the camera
• Attach the lens hood to the camera. Lens hoods attach by screwing into, clipping onto, or fitting over the outside of the lens
• Check the shadow of the lens hood. If direct light is passing into the lens, it will appear as a "lens flare". Adjust the lens hood to block direct light by twisting it on the lens
• Check the position of the lights, reflectors and subject. Using a lens hood is preferable in a studio situation in which the lights, reflectors, and subject are set up optimally, but light is still directly entering the lens and causing flares. If there is no better orientation for the studio lighting equipment or subject, a lens hood is the best choice to block excess, flaring light

Methods to Clean Mold on Camera Lens:

• Purchase a cleaning product. These include Clorox Germicidal Spray, Tilex Mildew Remover and 500 PSI Mask Scrub. You can use almost any product that removes mold on glasses or lenses. Read the warning label for the product you choose
• Rub the lens cloth over the camera lens. Remove any grime or dirt that is present. This will allow you to see the damage more clearly
• Dip one lens cloth in warm water. Squeeze out any surplus of water. Extra water can seep into the camera if not careful
• Wipe the lens with the damp cloth. Concentrate on the mold section and any small creases around the camera lens. This will move any remaining dirt
• Spray or pour a drop of cleaner on the second lens cloth. Polish the camera lens thoroughly. Cover ever part of the mold pores including around any creases
• Use the third lens cloth to wipe the moisture off. Towel it completely dry. Then store it in a safe, dry location

Package Included:

•  1 x MASSA 67mm Three Way Soft Rubber Lens Hood for Digital Film Camera