96cm Flexible Waterproof LED Light Ribbon Strip Green (DC 12V)

Specifications:

• Low voltage. Suitable for DC 12V power supply
• Energy saving and environment protection
• LED Light Strip can be cutted at the cutting can be connected up to 5m freely
• Waterproof for both exterior and interior use
• Can be installed in concave-convex surface
• Flexible LED Light Strip can be used night light, a garden decoration, a party decoration, a holiday decoration, ceiling, car, furniture, building or other place
• Color of Light: Green
• Number of LED: 96
• Length: 96cm / 37.8 in

Details: 

• Why not obtain this shiny Light Strip decorate your car

• Do not worry a lot, this Waterproof LED Light Strip is energy saving and environment protection

Usages:

• It can be used indoor

• It can be used outdoor

• It can be used car

How to Connect Motorcycle LED Lights:

• Locate areas under the motorcycle body or fairing where you would like to install the LED lights. Ensure that there are no hot motorcycle parts close to the locations you pick
• Clean the areas where you will be installing the lights with alcohol prep pads. This removes the dirt and grime. Allow the alcohol to dry thoroughly so the LEDs will have a clean, dry surface to attach to
• Remove the adhesive backings on the LEDs and install them by pressing them firmly against the motorcycle surface. Most LED light strips are flexible and can be curved around the fairing for better illumination
• Remove the seat and run the wires through the frame of the body to underneath the seat where the battery is located. The wires should not be visible on the outside of the bike
• Collect all the wires and tighten them together with a wire tie. This keeps the wires organized
• Loosen the terminal bolts on the motorcycle battery by using your screwdriver. Tighten the terminal bolts back into place so they firmly hold the wires down
• Start your motorcycle and watch your LEDs light up. If all or some of the LEDs are not operating properly, check the battery terminal connections first to ensure that they are tight. If the problem is not resolved, check the clamp connector wiring to ensure that all the wires are stripped properly and in full contact with the inside of the connector

Package Included:

• 1 x LED Flexible Ribbon