Camera Battery Grip Holder for Nikon D300 D700 STD-ND300

Specifications: 

• The battery grip is a multifunction battery pack for Nikon D300 D700
• The vertical shutter & function dial simplifies to shot pictures sideways   
• Professional battery grip adds power, comfort and flexibility to your Nikon camera
• Resist water and dust
• This is non-OEM product
• Size: 151 x 75.5 x 52mm/5.94 x 2.97 x 2.0in(L x W x H)

Details:

• This Camera Battery Grip has exceeded exposure function and infrared receiver
• The Camera Battery Grip is a multifunction battery pack for Nikon D300 D700

• The Camera Battery Grip is designed with vertical shooting shutter button and longitudinal main dial

• The Battery Grip Holder is designed with longitudinal aperture and exposure compensation button

• This Nikon Battery Grip provides more energy for your camera than a normal storage battery would

Size in Detail:



How to Install a Hand Grip Battery for a Digital Camera:

• The Digital Camera is an entry-level digital single-lens reflex camera, made for the "prosumer" market: the gray area between professional photographer and consumer. Professional accessories, including a battery grip, are available for the camera. This grip adds an extra shutter-release button, as well as storage for additional batteries, prolonging the shooting time available
• Turn the camera over to reveal the battery cover. Use your thumbnail to open the battery door. Hold the orange battery latch back using your thumb, then turn the camera over to drop the battery out of the camera
• Locate the hinge on the battery door. Pull the battery door toward the sides of the camera, at a slight angle, to break it free from the body. The battery door then clicks onto the body of the battery pack, at the vertical section that goes inside the camera
• Place the battery grip into the battery compartment of the camera until the tripod mount screw on the battery grip contacts the threaded hole on the base of the camera. Locate the knurled knob on the front of the battery grip. Turn it to the right to thread the battery grip into the tripod mount on the camera to lock it in place
• Turn on the camera to verify the battery grip is working correctly

Usage:

• Determine the camera's power switch has been set in the closed position, open the camera's battery compartment cover to carefully pull out the 35-degree angle, the camera battery inside the battery compartment out. To avoid dropping the battery can be up to the battery box cover is opened
• Camera battery box cover is stored in the handle of the camera battery compartment cover storage place to prevent loss
• Insert the handle column electrodes camera battery room, and to link the camera tripod screw toward the screw, according to tighten the connection as shown in the direction of hand wheel. Found between the camera body and the handle virtual spaces, you need to reinstall the handle
• Thus all the setup all finished. Open the camera power switch, and make sure the camera body there is information on the LCD display before use
• Installation steps can be removed in the opposite handle

NOTE:

• The handle can only be used with compatible devices
• In order to prevent physical access to the power terminal of metal caused a short circuit, do not use the handle, please cover Interface cover
• The handle does not equipped with power switch, use the camera power switch on or off the power
• The battery pack into fire or water, or directly to output short-circuit the battery pack
• Do not break down or assemble the battery pack
• Please use the specified charger to charge
• Independent place or time do not, remove the battery box battery

Package Included:

• 1 x Battery Grip
• 1 x Battery Box
• 1 x Remote Control
• 1 x Car Charger