Specifications:

• Hard Disk Cable Can converts Serial ATA to parallel ATA and Parallel ATA to Serial ATA  
• Hard Disk Cable Can connect hard disk to motherboard
• The Adapter Cable is simple to use, small form factor converter makes Displayport backwards
• Enable high quality optional digital audio transmissions
• Display port male to mini display port Hard Disk Cable
• Hot plug and play detection of this adapter cable as well as link status
• The Converter Cable can be a long time use 
• One 4pin power connector   
• Support ATA 100/133
• Size: 57 x 43 x 13mm / 2.3 x 1.7 x 0.5in (L x W x H)

Details:

• This is the power, SATA 2 and SATA 1 plug. Hard Disk Cable Can converts Serial ATA to parallel ATA and Parallel ATA to Serial ATA  

• This IDE to SATA Converter Adapter is suitable for installation in any computer case, as it is requires minimal space and does not impact airflow

• It's exactly what you need with best performance. The Adapter Cable is simple to use, small form factor converter makes Displayport backwards

Guide to Transfer IDE to SATA:

• Turn off your computer and unplug it from the power outlet. Remove the side case of the computer and set the computer down on a flat, level surface. Put on your anti-static wristband
• Take your IDE hard drive and place it into a free hard drive slot in your computer. Install the hard drive with four screws which will either be located inside the case or with the hard drive. Once the hard drive is securely in place, attach the IDE to SATA converter chip firmly to the hard drive
• Attach the SATA power cable to both the hard drive and to a free IDE power cable that is coming out of the computer's power supply unit (PSU). Attach the SATA data cable to both the hard drive and to the motherboard on the computer
• Re-attach the side of the computer, plug it in and power it on. If the installation was successful you will see the hard drive once you boot into the operating system. If the hard drive does not appear once you've logged in, check that all of your connections are secure and that no wires are loose or damaged inside the case

How to Install IDE to SATA Converter:

• Unplug the computer to reduce the risk of electrical shock
• Unscrew the retaining screws that hold the side panels of the computer to the rest of the case, and set them aside. Remove the case side panel
• Connect the IDE to SATA converter into the IDE drive. One side of the converter has SATA connectors, and the other side has a 40-pin IDE connector. The 40-pin IDE connector side should be firmly inserted into the back of the IDE drive
• Connect the 4-pin floppy power cable from the power supply unit to the back of the IDE to SATA converter. The 4-pin floppy power cable is white and about half the size of the rest of the connectors
• Connect an SATA cable from the back of the IDE to SATA converter to the motherboard
• Complete the installation by replacing the computer's side panel and tightening the retaining screws

Package Included:

• 1 x Adapter Storage Controller
• 2 x Data Cables