STD-ND90 Vertical Battery Grip for Nikon D80 D90

Specifications:

• Shoot Shutter: Half press focus, to facilitate vertical (portrait) shooting
• Multi-function Keys: You can adjust the menu, aperture size, shutter speed, and the camera's menu key and the primary function of the same as the deputy jog dial button
• Charging Interface: Can be used comes with charger charger
• Batteries Type: Lithium-ion batteries
• Charging Mode: CC / CV constant current / constant voltage
• Battery Capacity: 2800mAh
• Charging Time: 4h
• Output Voltage: 7.4V
• Operating Temperature: 0 ℃ -45 ℃
• Output Current: Max2.0A
• Storage Temperature: -20 ℃ -45 ℃
• Charging Voltage: 9V-12V
• Charge Current: Max1.0A
• Battery Size: 137.5 x 75.5 x 115.5mm / 5.4 x 3.0 x 4.5in(L x H x W)

Features:

• 2800mAh, it is 2 times for the original battery capacity
• Focus vertical shooting shutter half-press
• Original sense of the Battery Grip Holder
• Life cycle of 3-5 years
• By FCC / CE certification
• This is a NON-OEM product

Details:

• The nikon battery grip is a multifunction battery pack
• The nikon battery grip can be used in combination with the camera's batteries to extend the battery life and capture a large number of images without battery changes 

• Professional nikon battery grip adds power, comfort and flexibility to your camera

• This Nikon digital camera battery grip makes vertical-position shooting simple and effortless

Size in Detail:

How to Install a Hand Grip Battery for a Digital Camera:

• The Digital Camera is an entry-level digital single-lens reflex camera, made for the "prosumer" market: the gray area between professional photographer and consumer. Professional accessories, including a battery grip, are available for the camera. This grip adds an extra shutter-release button, as well as storage for additional batteries, prolonging the shooting time available
• Turn the camera over to reveal the battery cover. Use your thumbnail to open the battery door. Hold the orange battery latch back using your thumb, then turn the camera over to drop the battery out of the camera
• Locate the hinge on the battery door. Pull the battery door toward the sides of the camera, at a slight angle, to break it free from the body. The battery door then clicks onto the body of the battery pack, at the vertical section that goes inside the camera
• Place the battery grip into the battery compartment of the camera until the tripod mount screw on the battery grip contacts the threaded hole on the base of the camera. Locate the knurled knob on the front of the battery grip. Turn it to the right to thread the battery grip into the tripod mount on the camera to lock it in place
• Turn on the camera to verify the battery grip is working correctly

Usage:

• Determine the camera's power switch has been set in the closed position, open the camera's battery compartment cover to carefully pull out the 35-degree angle, the camera battery inside the battery compartment out. To avoid dropping the battery can be up to the battery box cover is opened
• Camera battery box cover is stored in the handle of the camera battery compartment cover storage place to prevent loss
• Insert the handle column electrodes camera battery room, and to link the camera tripod screw toward the screw, according to tighten the connection as shown in the direction of hand wheel. Found between the camera body and the handle virtual spaces, you need to reinstall the handle
• Thus all the setup all finished. Open the camera power switch, and make sure the camera body there is information on the LCD display before use
• Installation steps can be removed in the opposite handle

Package Included:

• 1 x Stdpower STD-ND90 Vertical Battery Grip
• 1 x Charger