Specifications:

• High capacity 850mAh battery
• Keep your portable devices running smoothly
• Conveniently portable and lightweight power station is great for phone users on the go
• Then simply plug the power station to your phone for charging at any where you go
• This is a non-OEM product
• Voltage: 3.7V
• Capacity: 850mAh
• Cell: Li-Polymer
• Size: 50 x 27 x 5mm / 2.0 x 1.1 x 0.2in(L x W x H)

Compatible with:

• Apple iPod 3G
• Apple iPod 3G M8976L
• Apple iPod 3G M9244LL
• Apple iPod 3G M9245LL
• Apple iPod 3G M9460LL
• Apple iPod 3G 10GB
• Apple iPod 3G 15GB
• Apple iPod 3G 20GB
• Apple iPod 3G 30GB
• Apple iPod 3G 40GB

Details:

• Great replacement battery for you iPod

• With this portable battery, you can enjoy extra hours on the device

How to Change the Battery on an iPod?

• The iPod, which began as a basic mp3 player, now has a number of different functions. Using an iPod, users can watch videos, listen to music, as well as make phone calls and access the Internet on some of its newest models. The iPod runs on an internal battery pack, which can sometimes get disconnected or simply stop functioning. If this happens, there is a simple process that allows users to reconnect or change their iPod battery themselves.
• Instructions
• Use the flat edge of something such as a knife or guitar pick to separate the two halves of the iPod's external case. Run the flat edged object around the border of the iPod to pop the case loose. After you have done this, you may notice that the two halves are still not coming apart. The front and back cases are held together by small plastic clips; you must squeeze the side of the front case inwards to get these clips to disengage
• Open the iPod gently. You will see a small ribbon connector that connects the front and back cases together. You will not need to disconnect this ribbon, simply lay both pieces flat directly next to each other. This will give you plenty of room to replace the battery without having to disconnect then reconnect the ribbon
• Remove the iPod's hard drive from the device by lifting up on the black tab located at the bottom of the hard drive. The device's hard drive is the blue rectangular piece that takes up most of the internal section of the iPod
• Remove the battery pack from the iPod. The battery pack rests underneath the hard drive. Once the hard drive is removed, you will see a smaller black rectangular piece with wires leading away from it; this is the battery pack you must remove. The battery should lift out with no problems, however, if it is stuck in place, run a flat, thin object around its border to free it from the device. Follow the wires to where they connect to the body of the iPod. Grip the white plastic base of the wires and pull the battery pack free from the device
• Attach the new battery in the same exact spot you removed it from. Push the white plastic base of the new battery's wire into the space allotted for it and lay the battery pack flat, making sure it fits perfectly back in the space you removed the old battery from. If you do not snap the battery pack down entirely, the other components will not fit correctly. Reassemble the remaining internal pieces by reinserting them in the exact same location from which you removed them

Li-ion Battery Storing Instructions:

• Do not let the first charge time to reach 12 hours. In our purchase of digital products with lithium batteries, a lot of store clerk will tell us that the first recharge time should reach 12 hours. In fact this is not quite right. Li-ion battery has been activated in the factory, the addition of lithium battery automatic discharge rate is very low, so we do not need to first charge the lithium battery a long time like an ordinary Ni-Cd / Ni-MH battery. Lithium battery can be used when full, usually after charge and discharge 3 to 5 full cycles (from full to run out as a full cycle) lithium batteries can achieve the best
• Do not use inferior charger. A lot of friends give very much love on their digital products, but ignore the lithium battery. When use the charger, if you can not use the original charger, it's necessary to use a good quality brand charger with an overcharge protection function. Inferior charger can make li-ion battery "short-lived," or even re-charge the battery to burst
• Do not often overcharge. Overcharge a long time will let the internal battery always in the "excitement" high-temperature state, which are all negative to lithium battery and charger. Therefore, the standard charge is to charge full. If the charger does not with an over-charge protection, it is very likely to make the lithium battery into a little bomb
• Do not touch metal objects. Lithium battery contact point need to always cleaning, but should pay attention to that when in storage and carry, do not let the battery contact point contacts with metal objects, which is easily lead to short-circuit, make the lithium battery short-lived
• Do not often use in hot or cold environment. Batteries have their own work and storage environment, for a long time at high and low temperature environment, will cause bad effects to the lithium battery use time and life expectancy
• Do not disuse or not to charge for a long time. If for some reason, the digital devices and lithium batteries may have more than 3 months idle time, then we need to on a regular basis to charge the lithium battery a certain amount of electricity, and then save (each charge accounts for the total battery capacity of 30% ~ 70%, depending on storage time and battery capacity)
• Do not immediately use the battery has just finished charging. The battery temperature is very high, if acted upon immediately into the DC and other equipments, the internal temperature of electronic equipment likely to cause rapid increases, which is extremely important to life span of electronic components

Li-ion Battery Charging Methods:

• Use a battery charger designed for lithium ion batteries. A charger for lithium batteries should be able to deliver 3.8 to 4.2 volts per cell. Never use a low power (trickle charge) system. This can cause lithium to adhere (plate) to the anode and oxygen to be generated at the cathode, producing an extremely flammable mixture. Lithium ion batteries come with an internal "safety board" that automatically terminates charging when the current rate drops to 10 percent of the initial charge rate, indicating the battery is fully charged. The best chargers also feature a timer you can set to stop the charging process at a preset time
• Place the lithium ion batteries in the charger and make sure it is plugged in. Depending on how much power remains in the battery it will take two to six hours to fully charge most lithium ion batteries. As an added safety precaution, set the timer to avoid the possibility of overcharging
• Charge the batteries at the appropriate voltage setting. To maximize the charge, the voltage should be set at 4.20 volts per cell. However, you can extend the useful life of lithium ion batteries by using a slightly lower setting (about 4.10 volts for most lithium ion batteries). This will give you about an 80 percent charge
• Charge lithium ion batteries to about 40 percent before storing them for long periods. It is not good for the battery to bring it to full charge and then store it, since this will reduce the battery's useful life. To further extend battery life, recharge stored batteries to the 40 percent level every few weeks (check the battery specifications for recommended times)

Package Included:

• 1 x 850mAh 3.7V Replacement Li-ion Battery with Tools for iPod
• 1 x Set of Tool Kit