- What is Slotted Screwdriver?
With slotted screwdrivers it is important to ensure that the tip matches the width of the screw slot, otherwise you run the risk of damaging the screw head. Slotted screwdrivers are available with either Flared or parallel tips. For the majority of uses the flared tip is ideal but if the screw needs to be driven below the material surface a parallel tip screwdriver should be used.
- What is the Pozidriv Screwdriver?
It is similar in appearance to the classic Phillips cross-head, but in fact is very different. The pozidriv has four additional points of contact, and does not have the rounded corners that the Phillips screw drive has. The biggest advantage it offers is that, when used with the correct tooling in good condition, it does not cam out, allowing great torque to be applied. The pozidriv screw can easily be distinguished by a line embossed in the screw head at 45 degrees to the slots for the driver.
- What is the Torx?
By design, TORX head screws resist cam-out much better than Phillips or slotted screws. Where Phillips heads were designed to cause the driver to cam out, to prevent over-tightening, TORX heads were designed to prevent it and to achieve a desired torque consistently. TORX screws are commonly found on vehicles, computer systems and consumer electronics, but are also becoming increasingly popular in construction. TORX head sizes are described using the capital letter "T", followed by a number. A smaller number corresponds to a smaller point-to-point dimension of the screw head.