High Quality 50m Cable Underwater Camera Monitor Systems with 7inch Color TFT LCD Monitor CR110-7C006A

Specifications:

• 7-inch TFT LCD underwater Video System
• 60deg Camera Vision Angle
• Video Input terminal
• Horizontal Resolution: 420TV lines
• 12V DC operatio
• Optional CCD Camera
• Waterproof Camera Cabinet
• Rechargeable Battery
• Optional 50m Cable
• Infrared 0 Lux Night Vision
• Can be connected to 2 Camera and VCR
• 3 Ways power supply:AC110/220V, 60/50Hz AC Adaptor (with Adaptor); DC12V-15V Car/boat cord; Battery power supply (rechargeable Batteries included)
• Easy carrying aluminum case

7 Inch TFT-LCD Color Monitor Specification:　

• Vision: TFT
• Display Made: 16:9
• System: PAL/NTSC
• Video Input: 1Vp-p 75Ω
• Consuming Power: <9.5W
• Power: DC 12V
• Resolution: 480(W) x RGB x 234(H)
• Operating Temperature: -10 ℃ ~ +50 ℃
• Storage Temperature: -20 ℃ ~ +60 ℃

Camera Specification:

• Input Voltage: DC 12V
• Image Sensor: 1/4 Sharp Color CCD
• Pixel Resolution: PAL: 500 x 582
• NTSC: 512 x 492
• Electronic Shutter: 1/60-1/5000 Sec
• Lens Angular Field of View: 60 Degree
• Cable Length: 50m
• Effective Focal Length: 6mm, 24 Light
• Maximum Relative Aperture: F/2.0
• Resolution: 420 TV Lines
• Video Signal Output: 1V(p-p) Composite Video Signal at 75ohm Termination
• Power Consumption: 1 Watt
• S/N Ratio: 40dB
• Packaging Material: High Impact ABS Plastic
• Operating Temperature: 50℉~+160℉
• Humidity: 100% Condensing

Detail:

Operation:

• Check switch on "OFF" position (button on high position), input power DC12V/500mA.
• Connect Video signal.
• Push switch on "ON" position (button on low position).
• Adjust Color and Bright knob at best result.
• Adjust screw on the frame at the best degree.
• Select to reverse picture in accordance with installment situation and usage need. Picture up/down/left/right, can be adjust by Remote Controller or keyon Monitor.

Attention:

• Please read the following manual details before using.
• Pay attention to damp proof for the high resolution.
• Don't break the LCD screen surface, and clean the surface by soft cloth if the screen dirty.
• Don't dismantle the unit by unprofessional.
• Push the unit L/R switch if find the Letter Reverse.
• Install the bottom side of the outer shell or inner side chamfer by customer's self-selection in accordance with bed frame.

Caution:

• The Camera must not be located to look directly into the sun or any other bright light source as this will not only result in a poor image, but will eventually damage the electronics of the Camera.
• Areas with a high degree of contrast in the light levels require careful positioning of the camera to obtain the best image.
• The best viewing angle is achieved by placing the Camera in a position where it is looking down on the subject.
• Additional lighting may be required if water quality is poor, or in low light conditions.
• The Camera has been tested underwater to a depth of 18 Meters. Any use below this depth will void the Camera's warranty.
• Always wash the Camera in warm water and soap after use, to remove salt and other corrosive agents.
• Always use appropriate water safety precautions when operating the Underwater Camera, and ensure appropriate level of supervision of children when near water.

Package Included:

• 1 x 7" inch Color TFT LCD Monitor
• 1 x Underwater Camera with Cable
• 1 x DC 12V Battery Charger
• 1 x 12V Sealed Lead-Acid Rechargeable Battery (Optional)
• 1 x Connector (for Battery charging only)
• 1 x Remote Control