7in True Touchscreen Car DVD Player System with GPS Navigator SL-6731-GT-2-001

Size in Detail:

How to Install an In-Dash DVD Player in Your Car:

In dash car DVD player is a great way to add high-quality mobile video to your vehicle. These devices are available from many manufacturers at a wide range of prices. Here's how to install one

• Open the hood of the car and disconnect the battery. You can disconnect the negative cable only and still be safe, but it's best to disconnect both the positive and the negative cable.
• Using the proper screwdriver, take out the screws holding the factory stereo in your car's dashboard, then remove the stereo from the dash. You may have to remove parts of the dash to take the stereo out.
• Carefully remove the connectors from the back of the stereo. Check the connectors to make sure they're not broken or dirty.
• You can buy a wiring harness designed for your vehicle at a car audio and video equipment dealer; these are intended for aftermarket installations. Connect the wiring harness to the car's connector. See the wiring harness instructions for the proper connection.
• Insert the in-dash DVD player in the aftermarket installation kit head unit. All dashboards are different, so you must buy an installation kit that matches the make of car.
• Connect the other end of the wiring harness to the back of the DVD player. Connect the antenna cable to the antenna input on the back of the DVD player.
• Insert the DVD player and the installation kit in the car's dash. Put in any screws that are required and replace any dash panels that you removed.
• Replace the battery cables and make sure they are tightened. Close the hood and turn on the car. The in-dash DVD player panel will light up if the installation was successful.

How to Maintain a Car DVD Player:

• Start basic and simply make sure the device is plugged in properly to the power outlet. You want to check for shorts in the power supply cord as well by jiggling the cord around and seeing if the device turns on and off
• Check the connections the DVD player has to the television set to make sure it is hooked up properly and that all connections are still functioning. Sometimes connections can come a bit loose and this can cause you to have problems as well. Tighten up the connections and see if the player begins working correctly
• Unscrew the DVD player housing and remove it from the device. Lift the clamp so that the DVD player lens is exposed for you to clean
• Take your canned air and spray away any dust off of the lens and any other part of the inside of the DVD player to remove excessive dust and build up. If a build up of dust gets on the lens, it will be unable to read the DVD discs you insert into your DVD player. It is good to routinely give your DVD player a good cleaning even when working properly to avoid build up
• Replace the DVD player housing and secure it back in place using the screwdriver. Turn on your DVD player and test your repairs. If the DVD player is still not working correctly, you may want to remove the DVD and give it a good cleaning as well with your canned air and wiping it with a soft cloth

Package Included:

• 1 x DVD Host
• 1 x Remote Control
• 1 x User Manual
• 1 x GPS Antenna
• 1 x iPod Cable
• 1 x USB Cable
• 1 x Connecting Cable