1:7 Latest Wireless Remote Control Rechargeable Large Car Toy

Specifications:

• Remote Control Car with outstanding scale speed and performance
• It races forward, back, left, right and stop
• With an easy to handle Remote Control, the controls of this Car Model Toy are intuitive and effective
• Wheel drive gives maximum acceleration, speed and stopping power and a responsive steering system allows for wonderful cornering
• Order one today and let your RC experience begin with a winner at one of the lowest prices in the biz
• The Remote Control Car Toy is the best gift for your kids
• Scale: 1:7 
• RC Distance: About 50m
• Charger Time: 8h
• Size: 56 x 24 x 19.5cm/22.0 x 9.4 x 7.6in(L x W x T)
• Wheel Size: 9.5cm
• Material: ABS Pastic & Etronic Dvices & Rubber (Tires) & Body Paint Processing
• Battery: 1 x AA 9.6V 900MAH Rechargeable batteries (Car)
• Frequency: 40MHz/27MHz
• Max Speed: 13km/h

Details:

• This Remote Control Car Model Toy can drive forward, back, left, or right, stop, highly detailed vehicle features and detailed interiors

• It's perfect for learning to drive and allows maximum performance for the more adventurous and skilled owners

• With an easy to handle Remote Control, the controls of this Rechargeable Car Model Toy are intuitive and effective

How to Install an RC Car Radio:

• Open the RC car to gain access to the chassis on which you'll be mounting the RC car radio. Remove the four clips that secure the body of the car to the chassis, placed in the four small posts extending through the surface of the car body. Remove any screws that may be holding the body of the car onto the chassis as well. Pull the car body upward from the chassis and set it aside
• Locate the radio mount within your RC car. The location of the mount differs by car manufacturer and model, so consult the manufacturer's instructions for mount location. Screw the radio receiver securely in place, making sure that the sockets for connecting the battery and speed controller and steering servo are face up
• Install the radio frequency crystal into the radio. Purchase the crystal as a matched pair with one meant for the radio receiver in the car and one for the radio transmitter in the remote control handset. Gently push the two prongs in the bottom of the crystal labeled Rx into the car radio until you've seated the crystal fully in place. Follow the same procedure to install the crystal labeled Tx in your remote control handset
• Plug your radio into the rest of the car's electronics system. Plug the control cable from the servo connected to your car's steering column into the socket marked CH1 on your radio, so you can control the steering from the remote handset. Plug the control cable from the electronic speed control in an electric car, or throttle servo in a Nitro car, into the socket in the radio marked CH2, so that you can control the speed of your car from the remote control handset. Finally, connect the cord from your car battery to the socket marked battery to provide power for your radio
• Turn on the RC radio handset and the RC car to test the car radio. Turn the wheel of the handset to test the connection. If the wheels of the car do not turn with the turning of the RC handset or the car begins to move then switch the CH1/CH2 plugs on the car radio. If either control does not respond, check connections and try again. When the controls respond correctly, turn off power to the RC handset and the car and then replace the car body for use of the vehicle

Package Included:

• 1 x Car
• 1 x Remote Control
• 1 x Charger
• 1 x Rechargeable Batteries
• 1 x Antenna
• 1 x Manual