Specifications:

• Shape: General shape, specially designed shape
• Special Shape: Heart-shaped, pentagonal shape, shape of snowflakes, Christmas tree and other shapes
• Power Supply: Battery: 2 AA or 3 AA (30 lamp beads within the product)
• Converter: DC 12V/24V
• DC Voltage: 3V DC
• Lamp Beads Spacing: 10cm
• Filament Color: Copper
• Light Color: Purple
• Length: 3m
• LED Number: 30

Features:

• Free to bend, give full play to your imagination talent
• Small size, rich colors
• High brightness, low power consumption
• LED string lights, high-quality, long life; all-sealed waterproof design
• Low-cost, low power consumption, the product effect is fantastic
• This LED string lights can waterproof

Details:

 

• Hang a strand of Bulb String Lights around trees and add a charming, decorative glow to your driveway, patio, or flowerbeds with this energy-efficient, low maintenance and beautiful led string light

• The Purple LED String Lights need 2 AA or 3 AA batteries. The Purple String Light has 3m with 30 lamps. Every Lamp Beads space 10cm

• Decorated according to their imagination free of any items to your beloved pet a sparkling necklace, to create a warm and colorful environment for you to enjoy life

How to Make a Battery Operated LED String Light

LEDs are as small as traditional string light bulbs, but they last up to 100,000 hours, use up to 90 percent less power, and they are almost indestructible under normal conditions. This makes them ideal for homemade battery-powered string lights. The amp-hour capacity of the battery, not the voltage, determines the maximum number of LEDs wired in a parallel circuit. LEDs consume very little current, so a parallel circuit is ideal. Making a light string requires the ability to use a soldering iron and wire-strippers.

• Determine the desired length of the string and the number of LEDs to be included in it. Divide the length of the string by the number of LEDs to establish the gap required between the LEDs for a string of equidistant lights. For example, in a 500 cm long string containing 100 LEDs the distance between the LEDs should be 500/100, or 5 cm. To the length of the light string, add sufficient extra wire to reach from the start of the lights to the battery. Cut two wires to this length.
• Strip the insulation from the final 5mm of each wire. Cut the LED legs to the desired length, and then solder the first LED across the ends of the two bare wires. Remember that all subsequent LEDs must have the same polarity, so be sure to note the orientation of the first LED.
• Work backward from the end of the light string, removing about 2mm of insulation from each wire at every equidistant point along both wires. Solder one LED across each pair of bared points along the wires. Connect battery clips to the ends of the wires.
• Connect the battery clips to the battery terminals, observing the correct polarity. Check the light string for LEDs that fail to illuminate. Identify the "dead" LEDs, disconnect the battery, unsolder the relevant LEDs and rotate them through 180 degrees. Re-solder them, reconnect the battery and check again. Replace any LEDs that still fail to illuminate.

Package Included: 

• 1 x LED String Light