5-Modes 160-280 Lumens CREE R2 LED Bulb

Specifications:

• A Cree R2 LED emitter
• Keep on hand with the Flashlight LED Bulb and you'll never be caught working in the dark
• The UltraFire 5-Modes CREE R2 LED bulb is used the UltraFire flashlight. It is made of high quality durable material
• The replacement 280 Lumens LED Bulb helps you keep your work area illuminated
• These bulbs each supply 280 lumens for bright light and dependable performance, it's easy to ensure that you always have a spare when you need one
• Alumium textured/OP reflector with copper heatsink base
• This is an OEM product
• Bezel Diameter: 26.5mm / 1.04 in
• Length: 29mm / 1.14 in
• Input Voltage Range: 3V~9V
• Maximum Brightness: 160~280 lumens

Details:

• Keep on hand with the Flashlight LED Bulb and you'll never be caught working in the dark

• The Flashlight LED Bulb is used the UltraFire flashlight. It is made of high quality durable material

• Alumium textured/OP reflector with copper heatsink base

Size in Detail:

How to Convert Streamlight Flashlight to LED?

Print this article A Streamlight-brand "C" cell flashlight provides a beam of light courtesy of an incandescent bulb and batteries. Increase the longevity of the light source and the power with which it is being supplied by replacing the incandescent bulb with a white LED. The white LED can be acquired from a hobby store or electronics shop. A few tools will be needed, none of which are unusual to have on hand in most homes. A partial disassembly of the Streamlight flashlight will be necessary.

• Place a sheet of newspaper on a table to protect the surface. Unscrew the reflector from the front of the Streamlight flashlight. Push the circular lens out of the reflector with your finger. Dispose of the lens in the trash. Place the reflector aside.
• Remove the retaining ring from the front of the flashlight. Place the retaining ring aside. Unscrew the battery compartment cover off the back of the flashlight. Remove the batteries. Place the batteries and the battery compartment cover aside.
• Unscrew the incandescent bulb from inside of the front of the flashlight with your fingers. Remove the incandescent bulb from the flashlight. Dispose of it properly.
• Insert needle-nosed pliers into the front of the flashlight. Grip the edge of the bulb module with the pliers. Twist the pliers as you pull the lamp module out of the front of the flashlight. Place the module face up on the newspaper.
• Heat up the soldering iron for five minutes. Apply a drop of solder to the center contact on the module. Apply a drop of solder to a spot on the contact surrounding the center contact. Let the solder cool for two minutes.
• Hold the white LED by the base with the two conductive pins at the bottom facing down. Place the tip of the soldering iron against the solder on the lamp module. Remove the soldering iron when the solder begins to bubble.
• Push the shorter of the two conductive pins against the solder on the center contact and the longer of the two conductive pins against the solder on the contact surrounding the center contact. Hold the conductive pins against the solder for 20 seconds before releasing the white LED. Let the solder cool for an additional two minutes.
• Grip the edge of the lamp module with the pliers. Reinsert the lamp module into the front of the flashlight. Place the retaining ring on the front of the flashlight. Screw on the reflector onto the front of the flashlight.

Package Included:

• 1 x CREE R2 LED Bulb