16CH H.264 Video Compression Network Security CCTV Standalone Digital Video Recorder with VGA Output CR-8316

Specifications:

• Channel and Input Level: 16CH,Composite 
• Video Input Signal Format: NTSC/PAL 
• Video Loss Check: Yes 
• Main Monitor Output: 1 CH BNC, 1CH VGA (XGA : 1024 x 768)
• Video Output Signal Format: NTSC/PAL & VGA
• Loop: 16CH 
• Spot: 1CH 
• Sensor Input (NC/NO Selectable): 16 
• Alarm Output: 4
• Compression: H.264 
• Multi-operation: QUADPLEX (Playback/Record/Network/Backup) 
• Record Resolution: NTSC :352x240, 704x240 ,704x480 / PAL : 352x288 ,704x288 , 704x576 
• Recording Mode: Continuous / Schedule / Motion/ Sensor/ Manual
• Motion Detection: Motion detection setup by Grid 
• Pre Recording: 1 fps for 3 seconds before an event 
• Post Recording: 10 seconds to 3 minutes after an event
• Display Frame Rate ( /Sec): NTSC: 30fps/ch, 60 fields / PAL: 25fps/ch, 50 fields
• Multi-Decoding: 1, 4, 9, 16
• Playback Speed Single Channel: x2, 4, 8 
• Multi-channels: x2, 4 
• Search Mode: Timeline, Event, Archive, Log 
• Interface Type: Serial ATA I 
• HDD Capacity: 1TB 
• Internal HDD No.: 3 (4: W/O CD-RW) 
• File System: NaFS 
• USB Flash Drive: Video & Still Image
• Built-in CD-RW: Video & Still Image
• Network: Video & Still Image 
• Menu Display: GUI 
• Input Method: Front key buttons, Remote control, Mouse, Key board controller
• Console: 1 RS-232C (9pin D-SUB connector) 
• PTZ Control & Keyboard DVR Control: 1 RS-485/1RS-422 
• Termination: Yes 
• Dynamic DNS: Yes (Free DDNS) 
• Network Interface: 10/100 base-TX Ethernet (RJ-45)
• Client Software (1:1): Live, Search, Backup, PTZF Camera Control
• Web Viewer (1:1): Live, Search, Backup, PTZF Camera Control(TBD for 16CH)
• Multi-sites Monitoring System (1:n): Live, Search, Backup, PTZF Camera Control
• DLS (Day Light Saving): Yes
• Internal Beep: By Alarm, Motion, Video Loss, HDD error 
• Multi-Language: Yes 
• S/W Upgrade: USB Flash drive 
• NTP: Yes 
• POS / ATM: Yes
• Watermark: Yes (Exclusive viewer support)
• Power Supply Voltage: AC 100-127V/200-240V, 50-60Hz, 280W
• Allowable Operation Temperature During Operation: 5°C - 40°C, During storage: -10°C - +50°C
• Allowable Operation Humidity: 0 - 90 % 
• H.264 Video compression
• Quadplex operation (Simultaneous Recording, Playback, Backup, and Networking)
• Reliable File system
• VGA&CVBS simultaneous display
• High quality VGA (1024X768)
• Recording speed from 120fps to 480fps
• 4channel audio recording
• Bi directional audio
• Individual channel operation
• Motion detection
• Automatic video input and video loss detection
• Covert camera operation provides enhanced security
• Built-in PTZF camera control
• Easy and simple user interface
• Easy scheduler
• Easy software upgrade
• Instant and convenient backup via USB flash drive, network or CD-RW
• Exclusive file format backup
• AVI backup
• 1TB SATA hard drive x MAX.4EA
• Various ways of network access via Network client software, Web-viewer, CMS and UMS(Multi-site monitoring software)
• Free Dynamic DNS

Details:

How to Replace a DVR Hard Drive:

• Disconnect your DVR by unplugging any cables connected to it, including the power cable. Remove the screws located on the back of the unit that hold the top cover in place. There are usually two to six of these screws, depending on the model of DVR. Lay these screws in a safe place where they won't get lost, and slide the cover off
• Locate the hard drive. This is a rectangular metal unit that measures 3 1/2 inches wide. It is usually located away from the other hardware, often in its own bracket. There will be two to four screws holding it in place. Remove these, disconnect the cables connected to the drive, and slide it out of the system
• Check the label of the drive to see if it is IDE or SATA. It will say which one of the two interfaces it uses. Any replacement desktop hard drive of the same interface type will work in your DVR. Avoid using a laptop drive, because they won't fit and aren't designed for the high-stress environment of video streaming
• Place the new drive into the brackets, and replace the screws that were removed from the old one. Plug the data and power cables into this drive. They will insert the same way they came out of the old one. Once the drive has been installed, put the cover back on the DVR unit, and replace the screws. Hook the DVR back up to the television, and it will be ready to record

How to Copy From a DVR to an External Hard Drive:

• Install video software on your computer. To properly process your data transfer, you need video software, which you can get from computer and electronics retailers or online. Simple, easy-to-use programs can be downloaded for free. Use reputable sites, such as CNET.com, to find some of the more reputable free programs. More advanced programs, with sophisticated editing capabilities, will usually only be available for purchase
• Connect your computer and DVR. In order to copy programs to your external hard drive, you need to transfer them to your computer. For older systems, and especially for desktop computers, you will need to use use RCA connectors to connect the DVR to the computer. RCA connectors are color-coordinated audio-visual cables used to connect electronics components, such as stereos and receivers, and they can be used with some computers and DVRs as well. Plug the yellow ends of the cable into the video jacks on the machines, then plug the red and white ends into the audio jacks. If you have a newer system, use USB cables to connect the computer and DVR. With a TiVo DVR and a wireless home network, you can connect your components wirelessly if you download proprietary TiVo software
• Transfer the program to your computer. Choose the program you wish to transfer from your DVR then press "Play" while pressing "Record" on your computer software program. The program should transfer in real-time. Monitor the recording and, when finished, check for quality
• Copy the program to your external hard drive. Using the video software on your computer, select your external drive as the destination for your next copy. Select the copy you just made from the DVR and make another copy on your external hard drive. Again, monitor the transfer and check for quality when you are finished

Package Included:

• 1 x 16CH Standalone DVR
• 1 x Remote Control
• 1 x Mouse
• 1 x Manual