Firefly KN-2016L Eyeshield 16 LED Desk Lamp Home Decor

Specifications:

• Rechargeable Battery: 2 x 4V/900mAh lead acid battery
• Charge Time: 12-15 hours
• Running Time: DC 6 hours, AC lighting
• Light Source: 16 LED
• Lamp Cap: 10.5cm/4.1in(L)
• Lamp Holder: 11.5 x 7.5cm/4.5 x 3in(L x W)
• Height: 40cm/15.7in

Features:

• This incredible creative LED Desk Lamp is made of special material
• This LED Desk Lamp is suitable for all kinds of rooms and is ready to run, there is not assemble necessary All you need to do is just put this creative desk lamp in your room to make your room cuter
• This LED Desk Lamp is also a good present for your friends and fans of creative home decor
• You don't need to worry about breaking anything when falling this decor lamp on the ground because of the material

Details:

• This incredible creative Night Light Lamp is made of high quality special material

• Use high-quality, ultra-low consumption, super-long life, energy saving and reliable

• This Decorative Night Light is also a good present for your friends and fans of creative home decor

Size in Detail:

How to Wire a Table Lamp:



When wiring a table lamp, always replace the cord and the socket for safety. Because you should never work on a lamp plugged into a wall outlet, the chance of being shocked when wiring a lamp is low. Prior electrical knowledge is not necessary when wiring a table lamp, and there is no mystery in this task. If you should incorrectly wire the lamp, it will simply fail to light. Once you have accomplished wiring a table lamp for the first time, you will be able to wire virtually any other lamp

• Untwist the finial from the shade rest and remove the lamp shade. Remove the light bulb. Squeeze the harp sides toward the lamp socket and lift the harp from the saddle. The saddle attaches to the lamp under the socket
• Take the socket apart by pulling the outer shell from the socket cap, exposing the cardboard insulator sleeve and the interior socket. Slip the insulator sleeve from the socket, exposing the socket terminals
• Loosen the two terminal screws, releasing the lamp wires from beneath them. Pull the interior socket from the socket cap and untwist the socket cap from the lamp base. Lay the lamp on its side and peel the felt from the bottom of the base, exposing the lamp wiring. Grasp the lamp cord from the exterior of the lamp base and pull the cord, removing it from the lamp
• Thread a new lamp cord set through the hole in the base of the lamp and up through the lamp body, extending it out from the top of the lamp. Thread the cord through the replacement socket cap and screw the socket cap onto the lamp body
• Slice apart 2 inches of the membrane connecting the two wires of the lamp cord. Tie a knot in the cord below the sliced wires
• Twist the smooth wire from the lamp cord around the silver screw on the replacement interior lamp socket and twist the ribbed wire around the brass screw on the socket then tighten both screws. Cover the interior socket with the cardboard insulator sleeve. Slide the outer socket shell over the sleeve, pushing it into the socket base. Replace the lamp harp, light bulb, lamp shade, felt and finial

Package Included:

• 1 x Desk Lamp