5m SMD 300 x 3528 LED Flexible LED Strip Light(DC 12V)

Specifications:

• Free to bend, give full play to your imagination talent
• Small size, rich colors
• High brightness, low power consumption
• LED lamps, high-quality, long life; all-sealed waterproof design
• Low-cost, low power consumption, the Flexible LED Strip Light effect is fantastic
• Widely used in room, hotels, clubs, shopping malls and other places decoration; construction and decoration, all kinds of decorative Flexible LED Strip Light boutiques; holidays, exhibitions, a variety of decorative LED lights can be used in bicycle, car decoration, etc.
• Operating Voltage: DC12V
• Output Power: 24W
• Length: 5m/16.4ft
• LED Type: 3528 PLCC-2 SMT SMD LED  
• LED Number: 300
• Size: 500.00 x 0.80 x 0.25cm/196.85 x 0.31 x 0.10in(L x W x H)

Details:

• Widely used in room, hotels, clubs, shopping malls and other places decoration; construction and decoration, all kinds of decorative 5m LED Strip Light boutiques; holidays, exhibitions, a variety of decorative LED lights can be used in bicycle, car decoration, etc

• 300 x 3528 LED Strip Light, high-quality amd long life, free to bend, give full play to your imagination talent

• Low-cost, low power consumption, the product effect is fantastic, the Flexible LED Strip Light can be used anywhere on your vehicle, both inside and outside, in fact anywhere you want to look a bit flashier

Usages:

• It can be used indoor

• It can be used outdoor

• It can be used car

How to Connect Motorcycle LED Lights:

• Locate areas under the motorcycle body or fairing where you would like to install the LED lights. Ensure that there are no hot motorcycle parts close to the locations you pick
• Clean the areas where you will be installing the lights with alcohol prep pads. This removes the dirt and grime. Allow the alcohol to dry thoroughly so the LEDs will have a clean, dry surface to attach to
• Remove the adhesive backings on the LEDs and install them by pressing them firmly against the motorcycle surface. Most LED light strips are flexible and can be curved around the fairing for better illumination
• Remove the seat and run the wires through the frame of the body to underneath the seat where the battery is located. The wires should not be visible on the outside of the bike
• Collect all the wires and tighten them together with a wire tie. This keeps the wires organized
• Loosen the terminal bolts on the motorcycle battery by using your screwdriver. Tighten the terminal bolts back into place so they firmly hold the wires down
• Start your motorcycle and watch your LEDs light up. If all or some of the LEDs are not operating properly, check the battery terminal connections first to ensure that they are tight. If the problem is not resolved, check the clamp connector wiring to ensure that all the wires are stripped properly and in full contact with the inside of the connector

Package Included:

• 1 x LED Flexible String Light