3.0inch Optical Glass LCD Screen Protector for DC/DSLR

Specifications:

• 3.0" optical glass Camera Screen Protector for DC / DSLR
• It is rigid and made of optical glass material, which achieves more than 90% of transmittance (higher than plastic LCD screen protectors), thus making the LCD screen clear
• Only 0.5mm thick with 4 layers of coatings and UV Protection
• Optical glass strengthened through special crafting process with this Screen Protector for Camera
• Prevent scratches, collisions and moderate impact to the Camera Screen Protector
• Camera Screen Protector is reusable
• Size: 65 x 50mm / 2.6 x 2.0in(L x W)

Details:

• 3.0inch Optical Glass LCD Screen Protector. Protect your investment with this LCD protective cover

• Optical glass strengthened through special crafting process, it is high transparency, anti-scrape, anti-bump, anti-aging and easy to install

• This LCD Screen Protector for DC/DSLR. This Camera Screen Protector is transparent and clear, so that you can barely notice it after attaching on the screen of your camera

• This hard cover is the ideal solution to keep the LCD of your a DSLR camera free from unwanted scratches, dust and debris

How to Clean Screen Protector:

• Remove the screen protector from your cell phone by gently peeling it up and off of the device by the corner. These protectors are designed so they can peel right off the screen
• Fill a bowl or your sink basin with warm water and add a small amount of liquid soap. Dip the screen protector in the water and rinse it gently and thoroughly
• Place your screen protector on a clean surface and allow it to dry completely. If you reapply your screen protector while it's still wet, it could result in moisture bubbles becoming trapped between the screen and protector
• Replace the screen protector on your iPod Touch after it has dried. At this point your Touch's screen protector should be completely clean

Basic Installation Guidelines:

• Wash your hands with soap and warm water to remove natural oils from your skin
• Wipe down your device with a clean, dry towel
• Do not use rubbing alcohol! Apply your new skin then show off your full-color glossy skin to everyone
• Installing your new skin on your device is a breeze
• Follow these simple install tips below to get the best results...
• And remember! If you come across any air bubbles or wrinkles during the process, simply run your finger over them and the channeled adhesive will allow the bubbles to be pressed out

Usage:

• No trimming required, fit directly on your LCD screen
• Just clean your LCD screen first, peel off the white back of the protector to stick, Done
• Easy to install and bubbles free, unlike plastic protector which always gives you bubbles between the protector and the screen
• No adhesive backing at the LCD screen, only at the border of the film for clearness
• Can be removed and reinstall, without leaving ugly residual on your LCD screen

Package Included:

• 1 x GGS 3.0" Optical Glass LCD Screen Protector for DC / DSLR