S105G Metal Frame IR Remote Control Helicopter Model

The coaxial RC helicopter has 2 sets of main rotor blades mounted one above the other. The main blades spin in opposite directions to each other, thus cancelling out each other's torque force. So, because there is no torque when both rotors are spinning at the same speed, the fuselage of the helicopter has no tendency to spin round in any particular direction. And that makes the RC helicopter while on hovering will be more stable

High quality material with great design, the Tail rotor can well offset the propeller's torque force. Keeps the helicopter in balance and provides great steering force

Helps to fly and land the helicopter stably and safely

Well packaged, the Electronic RC Helicopter Model comes in good condition to you. Fully assemble ready to fly, easy to fly

Unpacking the package, you will see a helicopter, a remote control, a tail rotor, a USB charging cable and a manual

Open the cover of battery case insert 6 AA batteries properly followed by polar indicator, shut the cover of battery case

Move the power switch on the helicopter to the “OFF” position

Charging Way A: Put down the charging wire cover of the back controller and put out the charging wire, then put into the interface of the helicopter, the green light on the controller will change red. The charging time is about 40-50 minutes. The glisten red light will change to be normal light when the helicopter is fully charged

Charging Way B: Put the USB charging wire into the computer USB interface, the charging wire will be light. Put the other side of the USB charging wire into the helicopter interface, USB charging wire light will be turn off. The charging time is about 40-50 minutes. Charging wire light will turn on when the helicopter is fully charged.