LCD Screen Protector Reflective Mirror Cover for iPhone 3G 3GS

Specifications:

• This iPhone 3G 3GS protector film is made of high quality plastic materials that is very lightweight and impact resistant
• Fully covers the entire front face of the iPhone for full protection, unlike other protectors that only covers the lighted screen section
• Easy to remove with no sticky residue
• Lightweight and impact resistant cell phone screen protector
• It protects your iPhone screen from scratches and removes glare
• Apple iPhone 3G 3GS screen guard is removable without leaving residuary mark
• Protects your LCD against scratching, scraping, and abrasion
• iPhone 3G 3GS LCD protector improves contrast
• Custom made to fit your iPhone perfectly
• This is a non-OEM product
• Compatible with: iPhone 3G 3GS
• Material: PVC
• Dimension: 109 x 56mm / 4.3 x 2.2in (L x W)

Details:

• This LCD Screen Protector can protect your cell phone screen against embarrassing scratches, grease marks, and finger prints while eliminating that awful glare

• Apart from keeping your devices scratch-free, the iPhone LCD Screen Protector provides some unexpected benefits

• Unlike cases, iPhone 3GS LCD Screen Protector uncompromising design doesn't take away from the look and feel of your device

Usage:

How to Clean a LCD Protector?

• Remove the protector from your device. Hold the protector under a stream of warm water in order to rinse it
• Apply one or two squirts of hand soap from a pump dispenser to the damp protector
• Hold the protector under a slow stream of warm water and then use your fingertips to gently rub the soapy mixture over the protector, removing any dust or other accumulation of dirt
• Rinse the protector again, holding it under a stream of warm water. Continue to rinse until all traces of soap are removed and the water runs clear
• Take the protector to a room or environment which is as free from dust as possible. Air-dry it by swinging it through the air vigorously until it has dried

How to Install a Screen Protector:

• Protecting a liquid crystal display on electronic equipment or a laptop is important ensure permanent damage does not occur to a delicate LCD. Installing protective film can be tricky because if the screen is not completely clean, dirt will be trapped beneath the screen protector. Additionally, if care is not taken to adhere the protector, it might not go on smoothly and without wrinkles

Instructions for Attaching a Screen Protector:

• Because many electronics devices have liquid crystal display screens, screen protectors have grown in popularity. To keep an LCD screen clean and avoid scratching the fragile surface, you should cover it with a clear screen protector. The screen protector adheres directly to the LCD screen and covers it entirely. With the screen protector in place, you can then relax and stop worrying about permanent scratches in the LCD screens of your electronic devices

Instructions:

• Clean the LCD screen of your electronic device with a cleaning cloth. You must make the LCD screen perfectly clean before you attach the screen protector; otherwise, any smudges will show through the screen protector
• Cut the screen protector to the correct size. Many screen protectors have a grid imprinted on the paper adhesive backing that makes it easy to cut in straight lines to trim your screen protector. If you err in size, make your screen protector slightly smaller than the LCD screen rather than slightly larger
• Turn the shower on in the bathroom and run it for approximately five minutes with the door closed. A moist environment is optimal for attaching a screen protector because less dust will accumulate on the LCD screen in this environment
• Turn the shower off and take your electronic device into the bathroom. Close the door
• Peel away one corner of the paper adhesive and begin attaching the screen protector to the LCD screen. Smooth the edge of the screen protector with a credit card to remove bubbles as you apply the screen protector. Continue peeling away the paper adhesive and pressing the credit card as you attach the screen protector until the screen protector is on completely.
• Run the edge of the credit card across the screen protector again to remove any remaining air bubbles

Package Included:

• 1 x LCD Screen Protector
• 1 x Cleaning Cloth