Complete Lower Dock Connector Assembly for iPhone 3G

Specifications:

• This is a completely assembled and ready to install Dock Connector Assembly for the iPhone 3G
• This Dock Connector Assembly is a much simpler task and eliminates the need for any soldering
• The Dock Connector Assembly comes with the Iphone 3g Dock Connector, loudspeaker, antenna flex, and transmitter microphone
• The Iphone 3g Dock Connector is easy to install
• Best  Iphone 3g Parts for you
• This is a non-OEM product
• Compatible with: iPhone 3G

Details:

• It is a much simpler task and eliminates the need for any soldering

• This is a completely assembled and ready to install lower dock assembly for the iPhone 3G

iPhone 3G Dock Connector Replacement:

• Step 1 - The defective dock connector assembly is on the left side, the new module that you are going to install on the right
• Step 2 - Slide the small flathead screwdriver under the end of the microphone ribbon cable and heat the two solder contacts with a soldering iron as you peel up the ribbon cable
• Step 3 - This is what it looks likes when the contacts are disconnected
• Step 4 - Do the same on the left side, disconnecting the iPhone loudspeaker
• Step 5 - Pry upwward carefully as you desolder the two contact with an electronics soldering iron
• Step 6 - This is what it looks like when both ribbon cables have been successfully disconnected
• Step 7 - Now peel off the defective dock connector module
• Step 8 - Install the new modul in the same position as the old one
• Step 9 - Hold down the loudspeaker ribbon cable with a flatheat screwdriver and reconnect the contacts with a soldering iron
• Step 10 - Do the same with the microphone's ribbon cable
• Step 11 - Reinstall the dock connector assembly in the backplate and then reinstall the iPhone 3G logic board. Be sure to take off the foam distance piece with then number 3 sticker and install it on the new dock connector module

Package Included:

• 1 x New Lower Dock Connector Assembly for iPhone 3G