Crown Pattern Rhinestone Hard Plastic Back Case Cover for iPhone 4

Specifications:

• The iPhone Rhinestone Case features a crown pattern
• This iPhone Back Cover protect your phone from the scratch
• Perfect cutouts give easy access to all phone functions without having to remove the case
• With its elegant and contemporary design, this iPhone Back Cover is very popular
• All function buttons and ports are accessible without removing skin cover
• This iPhone back cover can provide good protection that's unbelievably tough
• This iPhone Plastic Cover is easy to insert and remove, and no tools to be used  
• This is a non-OEM product
• Material: Plastic
• Compatible with: iPhone 4
• Size: 115 x 62 x 12cm / 4.5 x 2.4 x 0.5in (L x W x H)

Details:

• This iPhone Back Cover protect your phone from the scratch

• Easy to install and take off

• This iPhone back cover can provide good protection that's unbelievably tough

• The iPhone Rhinestone Case features a crown pattern

Size in Detail:

How to Replace an iPhone Back Cover:

• Apple's iPhone is one of the most popular cell phone devices available. One of its most popular features is its sleek design. The front features a wide front screen, which is perfect for taking pictures, displaying pictures, and showing video. And the back is a sleek, silver cover which helps the device look ultra modern. The only problem is the back cover often becomes dull and scratched up, which can devalue the phone. In order to maintain your iPhone's value and appearance, you may need to change the back cover.
• Power off your iPhone and disconnect it from any power source
• Straighten the paperclip out. Push the paper clip into the SIM card hole, which is also the smallest hole, on the top of the iPhone. The SIM card will pop out. Remove the SIM card
• Flip the iPhone over to work on the back of it. On the back run Flathead screwdriver, or other thin flat tool, in the crease between the bottom, black plastic cover and the silver back casing. Then slide off the black plastic cover
• Remove the three screws that are connecting the iPhone's silver backing with the mini Philips-head screwdriver. Set the screws to the side
• Run the flat head screwdriver along both sides of the back of the case again to loosen the back of the case from the front. Be careful not to bend the back case when doing this
• Lift up the back case. You will notice a ribbon connecting the back case to the motherboard. Pop the ribbon up, carefully, with your flat head screwdriver
• Plug in the ribbon to your new back cover
• Place the back cover down, and screw in the three screws that held the old one in place