Universal 24V to 12V Power Supply 20A Direct Current Converter

Specification:

• Material: Aluminum Alloy
• Color: White
• Input Voltage: 24V
• Output Voltage: 12V
• Direct Current: 20A

Features:

• Made of good quality material, this kind of DC Converter is durable enough for you to use
• The DC converter with security guarantee will surely offer you much convenience for your daily life
• This 12V power converter will surely protect your devices from over current voltage, overheat and short-circuit
• With this high voltage converter, you can operate your electronic devices better
• This type of DC converter is very easy to install and carry, and you will not get hurt when operate properly
• The DC converter is suitable for many professional uses, so it is pretty popular in the market

Details:

• The overall design of the direct current converter is very simple and concise

• The direct current converter transform DC 24 voltage input into DC 12 voltage output

• The different colors of power cords allow you to install it easily and safely 

• The DC converter is made of high quality material, so you can use it for a long time

• The DC converter is lightweight and small, you can move it easily if necessary

How to Wire an AC to DC Converter:

• Remove the thumb screws or wing nuts from the DC power terminals of your AC to DC converter by turning them to the left
• Strip 1/2 inch of insulation from the positive and negative wires of the DC device you'll be connecting the AC to DC converter to. In virtually every case these wires will be colored red and black respectively, but check your device's manual or wiring diagram to be sure
• Slide a ring terminal onto the bare ends of each wire and then crimp the terminal onto the wire with a crimping tool
• Put the positive and negative wires onto the positive and negative posts of the AC to DC converter and tighten them down with the thumb screws or wing nuts
• Plug the AC plug into a wall outlet. Turn on the AC to DC converter to provide power for your DC device

How to Wire a Power Converter:

DC to AC Inverters:

• Place the inverter close to the battery. The inverter usually only has two wires that run from the unit. Those are the battery wire connections
• Connect the red wire to the positive post of the battery. Then connect the Black wire to the negative post of the battery
• Turn on the power inverter. The inverter outputs come in the form of an electrical outlet built into the unit. To get the AC power out, just plug the device needing power into the outlet

AC to DC Adaptors and Power Supplies:

• Look at the adaptor. Adaptors are very simple. Plug the AC end of the adaptor into a wall socket
• Route the adaptor wire over to the device needing power, and plug it into the device needing power. Power supplies have terminals mounted on the front of the unit which allow wires to be connected to run various devices and experiments. The terminals are labeled positive and negative
• Test the load device by turning it on to verify that it works

Package Included:

• 1 x Direct Current Converter