1/4" Color CMOS 170° Wide Angle Car Rear View Camera for Roewe 750 HL-5811

Specifications:

• Mounting lamp instead of lighting facilities
• With distance label
• Support 170° wide viewing angle
• With high resolution image, you can see the back road situation clearly
• A practical device for backing-up or parking more safely
• It is very easy to use and install
• Mounting lamp instead of lighting facilities
• This is a non-OEM product
• Compatible with: Roewe 750
• IP Rating: IP66
• TV Lines: 420 TV Lines
• Sensor: 1/4" color CMOS
• System: NTSC/PAL
• Numbers of Pixels: 580 x 492 / 628 x 492
• Lens Angle: 170 degrees
• Operating Temperature: -25～+75°C
• Operating Voltage: DC 12V
• Minimum Illumination: 0.2 LUX  

Details:

• The rear-view camera usually does permit the camera to view a continuous horizontal view from one corner, behind the car, to another

How to Install a Rear-View Camera in Your Car:

• Disconnect the battery cables from the battery. Check the vehicle's repair manual to find out what size wrench to use. Leave the disconnected cables a safe distance from the battery posts
• Decide where you want to install the rear-view camera. Most people put them in the plastic bumper so they don't have to drill into the car's sheet metal
• Drill a hole for the camera. Check the installation instructions to see what size drill bit to use. Don't make the hole too large or the camera will fall out
• Place the camera in the hole using the rubber grommet supplied with the camera. Make sure the camera and grommet are tight
• Attach the camera's power wire to the backup-light power wire on your car. You'll have to splice the wires together. Use wire cutters to cut the wires, leaving enough excess wire to reconnect. Strip the ends of the wire to expose the bare wire using wire strippers. Splice the wires together using a two-into-one connector. This will give the rear-view camera power when you put the car in reverse
• Route the camera's output wire to the rear-view monitor and connect the wire to the monitor's input. For installation of the monitor, see the monitor's installation instructions
• Reconnect the battery, start the car and put the car in reverse. The rear-view monitor should turn on and give you a view of what's behind you

Package Included:

• 1 x Car Rear View Camera
• 1 x User Manual
• 1 x Positive - Negative Power Connection Cable