Specifications:
- This protector is made of high quality material that is very lightweight and impact resistant
- Fully covers the entire front face of the screen for full protection
- LCD Screen Protector protects your screen from scratches and removes glare
- It is removable without leaving residuary mark
- Protects your screen against scratching, scraping, and abrasion
- Custom made to fit perfectly
- This is a non-OEM product
- Dimensions: Approx. 71mm/2.8in
Details:


- This LCD Screen Protector for SONY PSP protects screen against embarrassing scratches, grease marks, and finger prints while eliminating that awful glare

- This PSP Screen Protector is made of high quality material that is very lightweight and impact resistant

- This SONY Screen Protector is removable without leaving residuary mark
How to Clean Screen Protector:
- Remove the screen protector from your cell phone by gently peeling it up and off of the device by the corner. These protectors are designed so they can peel right off the screen
- Fill a bowl or your sink basin with warm water and add a small amount of liquid soap. Dip the screen protector in the water and rinse it gently and thoroughly
- Place your screen protector on a clean surface and allow it to dry completely. If you reapply your screen protector while it's still wet, it could result in moisture bubbles becoming trapped between the screen and protector
- Replace the screen protector on your iPod Touch after it has dried. At this point your Touch's screen protector should be completely clean
Basic Installation Guidelines:
- Wash your hands with soap and warm water to remove natural oils from your skin
- Wipe down your device with a clean, dry towel
- Do not use rubbing alcohol! Apply your new skin then show off your full-color glossy skin to everyone
- Installing your new skin on your device is a breeze
- Follow these simple install tips below to get the best results...
- And remember! If you come across any air bubbles or wrinkles during the process, simply run your finger over them and the channeled adhesive will allow the bubbles to be pressed out
Usage Method:
- Clean the screen thoroughly
- Expose 1/2 inch of the screen guard. Take care not to touch the adhesive side
- Align the exposed section with the edges of LCD screen. Make sure the screen guard has been pacing straightly
- Peel off the mask with the provided sticker after application completed
Package Included:
- 1 x LCD Screen Protector for SONY PSP
- 1 x Screen Cleaner